Specification:
The Delco air temperature sensor is an analogue sensor with a 0 to 5 V output (working range is generally 0.5 V to 4.5 V). The sensor signal wire can be used with any Analogue Temperature (AT) input on compatible devices, see the signal pin table below. Connection is to a 0 V sensor ground, and is to the same device that is reading the signal. Both the 0 V and signal connection have no specific polarity and can be wired either way.
Suitable for use with:
M84 ECU
Hundred series ECUs
M1 series ECUs
All MoTeC data loggers
Related Products
- AED: د.إ 40
This item is the vehicle Specific harness required for the Installation of HKS Turbo timer.
4 in stock
- AED: د.إ 3.599
This cluster was oem 180km and we replaced the nismo speedometer 320km with motor , so it will running real 320km in the speedometer not just face design.
1 in stock
- AED: د.إ 2.350
MoTeC LTC (Lambda to CAN) module interprets the data from a wideband Lambda sensor and transmits sensor data for monitoring, control and diagnostics on a CAN bus.
It is compatible with any ECU, Dash or Logger present on the bus.
Available in several variants:
Bosch LSU 4.9 or NTK Lambda sensor.
Single or Dual sensor version.
200 or 650mm lengths (LTC Long)
1 in stock
- AED: د.إ 826
Defi-Link Display is a multipurpose monitor which provides information on speed, oil temperature, water temperature, oil pressure, fuel pressure, and exhaust temperature by connecting to the Defi-Link Control Unit II or the Defi-Link Control Unit.
Universal for jdm cars
Condition : New.
1 in stock
- AED: د.إ 1.465
Setting Mode allows full access to the 20×20 ignition timing and fuel correction maps. The user can adjust any portion of this map.
1 in stock
- AED: د.إ 206
Not original speedometer just face design.
CONDITION : New
1 in stock
- AED: د.إ 4.260
Nissan R35 GTR GT-R VR38DETT.
1 in stock
- AED: د.إ 1.083
2003-2006 Dodge Ram 1500-3500 5.7L Hemi
2005-2006 Dodge Durango, Jeep Commander, Jeep Grand Cherokee 5.7L Hemi
2007-2008 Dodge Grand Caravan, Jeep Wrangler, Pacifica 3.8L V6
2 in stock
- AED: د.إ 775
The 500 PSI (3446 KPa) TI pressure sensor is a 0 to 500 PSI gauge pressure sensor suitable for use with fluids in applications such as fuel, oil or coolant pressure.
1 in stock
- AED: د.إ 1.208
Customized wiring kit for Motec ECU.
Can be connected with original engine wires ( no need to fabricate the original wiring).
Recommended to work on it with professional electrical.
It was installed on GTR32 and everything is working normally with Motec M600.
Condition : used.
1 in stock
- AED: د.إ 966
Universal.
Condition : used.
can be seen from the photos I have powered it up to check it works.
It was purchased for my car but I am putting an aftermarket ecu in so don’t need this now.
This unit is rare and not available any longer from apexi.
1 in stock
- AED: د.إ 914
Condition : used.
Installation is as easy as replacing the factory ECU. (Some minor rewiring is required on select vehicles.) The factory engine harness does not need to be replaced and all critical accessories such as air conditioning continue to function. By using the optional Apexi Power FC Commander, the user can adjust and modify a wide range of settings. By changing various parameters and data, the Apexi Power FC will adapt to any of your performance needs.
1 in stock