Specification:
The Delco air temperature sensor is an analogue sensor with a 0 to 5 V output (working range is generally 0.5 V to 4.5 V). The sensor signal wire can be used with any Analogue Temperature (AT) input on compatible devices, see the signal pin table below. Connection is to a 0 V sensor ground, and is to the same device that is reading the signal. Both the 0 V and signal connection have no specific polarity and can be wired either way.
Suitable for use with:
M84 ECU
Hundred series ECUs
M1 series ECUs
All MoTeC data loggers
Related Products
Out of stock
This item is the vehicle Specific harness required for the Installation of HKS Turbo timer.
4 in stock
Condition : used.
Setting Mode allows full access to the 20×20 ignition timing and fuel correction maps. The user can adjust any portion of this map.
Out of stock
Discontinued Item.
Brand new.
Universal for jdm cars.
1 in stock
Universal for jdm cars.
2 in stock
Condition : used.
Installation is as easy as replacing the factory ECU. (Some minor rewiring is required on select vehicles.) The factory engine harness does not need to be replaced and all critical accessories such as air conditioning continue to function. By using the optional Apexi Power FC Commander, the user can adjust and modify a wide range of settings. By changing various parameters and data, the Apexi Power FC will adapt to any of your performance needs.
1 in stock
2003-2006 Dodge Ram 1500-3500 5.7L Hemi
2005-2006 Dodge Durango, Jeep Commander, Jeep Grand Cherokee 5.7L Hemi
2007-2008 Dodge Grand Caravan, Jeep Wrangler, Pacifica 3.8L V6
2 in stock
MoTeC LTC (Lambda to CAN) module interprets the data from a wideband Lambda sensor and transmits sensor data for monitoring, control and diagnostics on a CAN bus.
It is compatible with any ECU, Dash or Logger present on the bus.
Available in several variants:
Bosch LSU 4.9 or NTK Lambda sensor.
Single or Dual sensor version.
200 or 650mm lengths (LTC Long)
Out of stock
Defi-Link Display is a multipurpose monitor which provides information on speed, oil temperature, water temperature, oil pressure, fuel pressure, and exhaust temperature by connecting to the Defi-Link Control Unit II or the Defi-Link Control Unit.
Universal for jdm cars
Condition : New.
1 in stock
Condition : Used ( just used for 1 week only ).
The Defi Sports Display F (DSDF) is a multifunctional digital display for vehicles that uses the existing Defi Advance Control unit for an easy to install sensor information system.
1 in stock
Condition : used.
Setting Mode allows full access to the 20×20 ignition timing and fuel correction maps.
Out of stock
Used in many aftermarket ECU applications such as Haltech, Link, Motec, Emtron etc.
Also used in Innovate & AEM stand alone wideband gauges. Commonly used with dynos such as Mainline.
Out of stock
